
Warmer red tones and tighter joints for brick
Brick Paver Sealing in Apopka, FL
Request a free brick paver sealing quote in Apopka, or call (689) 529-7659.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who can seal the brick pavers at my Apopka house?
A local contractor seals brick pavers in Apopka, FL, and the reply arrives inside 1 business day, usually well ahead of it. The quote is free, and nothing obliges you to book. To start, call (689) 529-7659.
Brick looks warm when it is clean, then turns dull and blotchy as the damp air has its way. Green film settles into the joints, the red fades toward orange, and a pale haze sometimes creeps up the face. A sealer picked for brick can bring the color forward again and make the surface easier to rinse. Say what the brick is laid on and where it sits when you ask for a free estimate.
Is my Apopka brick clay or concrete, and does it matter?
It matters because the two drink water differently. Wikipedia says clay brick is fired in a kiln near 900 to 1,000 degrees Celsius, and its color comes from the iron and lime in the clay. Concrete pavers are cast from sand, stone, cement and iron oxide pigment, and concrete paving brick is described as porous. Kennelly Paver Sealing says brick and natural stone need different sealers and processes. To have yours identified, call (689) 529-7659.
How a contractor can tell
Chipped edges show the material, and so does the back of a loose piece. A contractor can also test a small patch. Bring it up when you ask for a free estimate.
Why the sealer name matters
Castle Clean and Seal calls water-based sealer the Florida standard because moisture can escape, and says solvent-based products can turn white and peel in humidity. On a porous surface that is a bigger risk. Ask for the product by name, then call (689) 529-7659 if the bid does not list it.

What does brick paver sealing cost in Apopka?
Kennelly Paver Sealing lists $1.50 to $3.00 per square foot to clean, sand and seal brick pavers, or $750 to $3,000 for a 500 to 1,000 square foot job. Castle Clean and Seal lists the same overall $1.50 to $3.00 range, notes that surface type such as brick changes the price and adds a $1,000 minimum. For a price on your own brick, ask for a free estimate.
| Brick area | What it looks like | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Front walk and stoop | $1,000 minimum applies (math is $450 to $900) |
| 500 sq ft | Back patio | $750 to $1,500 |
| 750 sq ft | Patio plus walkway | $1,125 to $2,250 |
| 1,000 sq ft | Large patio or short drive | $1,500 to $3,000 |
Math at the $1.50 to $3.00 per square foot that Kennelly Paver Sealing and Castle Clean and Seal published for 2026. Kennelly lists $3.50 to $5.00 per square foot ($1,750 to $5,000) to strip and reseal a failed coat. The real price comes from the contractor after a look.
Strip and reseal costs more
Brick that already wears a failed coat has to lose it before a new one goes on. Kennelly says those jobs take two to three days, and Castle adds $500 to $1,000 or more for stripping. Share a photo of any peeling when you call (689) 529-7659.
How does the brick sealing process work?
The steps match other paver jobs, but the gentle touch matters more on brick. To walk through the order for your surface, call (689) 529-7659.
Inspect and test
The contractor checks for loose brick, chipped faces and low joints, and may test a small spot. Settle what stays and what gets replaced before any water is sprayed. When you want that visit, ask for a free estimate.
Wash with care
Hard blasting can scar a porous face and empty the joints, so the wash stays low pressure. Brick near planting beds gets the same care. Ask about the nozzle and pressure when you call (689) 529-7659.
Sand, dry and seal
Sand fills the joints, the brick dries all the way and the sealer goes on in even coats. Wikipedia notes that joint sand gives pavers the friction that holds them in place under traffic. Confirm sand is part of the bid when you ask for a free estimate.
Cure time
Kennelly says a water-based coat is walkable in 3 to 4 hours and cured in 24 to 48, and a solvent-based one can take up to 72. Keep pets and sprinklers off the brick meanwhile. Call (689) 529-7659 to settle the day.
Why does brick get a white haze in Apopka?
The Orlando Paver Sealing Company calls efflorescence a natural white haze that forms after repeated soaking, and says it usually fades with time. Wikipedia explains it as salt carried to a porous surface by water that then evaporates. Primary deposits are described as brushable. Apopka's 50 inches of rain a year keep moisture moving through brick. To ask what a contractor does about haze, ask for a free estimate.
What a sealer can and cannot do
Wikipedia says modern vapor-permeable repellents keep liquid water out while letting vapor escape, and that they cannot permanently stop the problem. That is why a contractor should never promise it is gone for good. If a bid does, call (689) 529-7659 for a second opinion.
Which Apopka brick surfaces get sealed most often?
Front walks, courtyard patios and pool surrounds lead the list, and each ages in its own way. A brick walk through a shaded bed stays damp and grows algae. An open patio loses color to sun. Apopka has old buildings and new subdivisions side by side, and every home needs its own plan. To start with the surface that bothers you most, ask for a free estimate.
Matching an older house
Brick that sits next to a painted wall or a tile roof shows its age against them. Mention the age of your house and any past sealing when you call (689) 529-7659.
How long does a brick seal last in Apopka?
Two to four years, the range Kennelly Paver Sealing and the Orlando Paver Sealing Company both give. Kennelly says a shaded surface with light traffic can reach about four, and that cleaning every 12 to 15 months helps. Brick under oaks may hold a coat longer than brick in open sun. To check an older coat, call (689) 529-7659.
What cannot sealing fix on brick pavers in Apopka?
Sealer is a finish and not a repair. A Central Florida paver company says sealers do not stop stains, mildew, weeds or fading, and that stains which sat for months or years may not come out. On brick, those limits matter more because the face is porous. To go through your brick, call (689) 529-7659.
Cracked or flaking faces
Brick with chipped or flaking faces needs replacing, not coating. Check the paver restoration and resealing page if a section has moved or failed. Show the contractor any damage when you ask for a free estimate.
Deep rust and oil stains
Porous brick holds stains, and the paver stain removal page explains what a treatment can do. A test patch comes first. Point out each mark when you call (689) 529-7659.
Moss and algae in the joints
Damp joints grow green fast in Apopka, and the paver cleaning page covers the wash that comes before any coat. To book both together, ask for a free estimate.
How do I get my Apopka brick ready for sealing?
Brick needs little from you, but a few steps help. Kennelly Paver Sealing says furniture, grills and plants must be moved, and that applies to a brick courtyard as much as a back patio. To confirm yours, call (689) 529-7659.
Clear the surface
Planters, furniture and doormats come off the brick, and any loose pieces get marked. Tell the contractor about wobbling brick when you ask for a free estimate.
Check the beds beside the brick
Brick walks often run beside planting beds, and cleaners and overspray need to stay out of them. Ask how plants will be protected when you call (689) 529-7659.
Allow time to dry and cure
Castle asks for 4 to 6 hours off the surface, and longer when the air is humid, the spot is shaded or rain is near. Plan the day around that, then ask for a free estimate.
What does sealed brick look like around Apopka?








Which towns near Apopka can book brick paver sealing?
The towns around Apopka are covered as well, each with its own page. If yours is missing, call (689) 529-7659.
What do Apopka homeowners ask about sealing brick pavers?
How to seal brick patio pavers?
A contractor cleans the brick, refills the joints with sand, lets it dry and puts on a sealer chosen for the material. Kennelly Paver Sealing says brick and natural stone need different sealers and processes, so the product name is the question to ask.
How long does paver sealing last in Florida?
Orlando-area companies give two to four years. Heavy sun and daily traffic push it toward two, and a shaded, lightly used brick patio can reach about four. A cleaning every 12 to 15 months helps.
How much is paver sealing in Florida?
Kennelly Paver Sealing lists $1.50 to $3.00 per square foot to clean, sand and seal brick pavers, or $750 to $3,000 for a 500 to 1,000 square foot job. Stripping and resealing a failed coat runs $3.50 to $5.00.
Is it necessary to seal pavers in Florida?
Nothing requires it, but it is common. Orlando-area companies point to rain, humidity and sun as the reasons, and a sealed surface holds color and rinses cleaner. Unsealed brick still works, with more scrubbing and sand.
What is the average cost to seal pavers in Florida?
Two Central Florida companies publish $1.50 to $3.00 per square foot for the full job, and a third starts at $1.75. A job under about 500 square feet can fall under a $1,000 minimum.
Is clay brick sealed the same way as concrete pavers?
Not always. Wikipedia says concrete pavers are cast from sand, stone, cement and pigment, while clay brick is fired in a kiln near 900 to 1,000 degrees Celsius, so the two take water differently. Kennelly says brick and stone need different sealers, so ask which type you have.
Will sealing stop the white haze on my brick pavers?
It may slow it, and no sealer promises to stop it. The Orlando Paver Sealing Company says efflorescence usually fades with time, and Wikipedia says repellents cannot permanently prevent it. Brushing off a light deposit is normal.
Does brick fade in the Apopka sun?
Color does lighten under sun and weather, and Central Florida companies list fading among the reasons to seal. Wikipedia says brick color comes from iron and lime content in the clay and firing. A sealer coat slows the dulling, though it does not stop it.
Do I need to seal old brick that was never sealed?
Not necessarily. A contractor can test a small spot and tell you what a coat would change. Sealing is recommended soon after a new installation, and a paver company in Orlando says cleaning and sealing can restore old, faded pavers.
Bring the brick back to its warm color
Describe your brick and where it sits, and a local contractor answers inside 1 business day, often sooner.
Free, no obligation
